厂家直销HCB-H001浴室玻璃门圆管拉手 L字型耐高温拉手

怎么安装玻璃门前拉手？

How to install glass door handle？

1、全玻璃门扇上玻璃门拉手孔洞，一般在裁割玻璃时加工完成。玻璃门拉手连接部分插洞口时不能过紧，应略有松动；如插入过松，可在插入部分裹上软质胶带。  

1、Glass door handle holes, generally in cutting glass processing to complete. Glass door handle connecting portion in the hole cannot be too tight should be slightly loose; such as inserting too loose, can be inserted in the partially wrapped soft tape.

2、安装前在玻璃门拉手插入玻璃的部分涂少许玻璃胶。拉手组装时，其根部与玻璃靠紧密后再按紧固定螺钉，以保证拉手没有松动现象。

2、Before install the glass door handle , we can spread on some glass cement in the glass door hole. When the handle is assembled, the root of the handle is tightly pressed by the glass, and then presses the fastening screw to ensure that the handle is not loose.

 3、如果玻璃门不是钢化玻璃的话，用10mm的玻璃钻头，量出玻璃门拉手的孔距（中心到中心），在玻璃门上标记好，浇水打孔，安装时先从外面上，在里面拧好拉手的长螺丝，别把拉手的螺丝留外面了，那样能够从外面把玻璃门拉手卸掉的。

3、If the glass door not toughened glass，measure the glass door handle hole spacing（from center to center），marking，watering and using 10mm glass bit dig the hole in the glass door. Firstly installation outside，tighten the screws inside，do not let the screws to stay outside the surface that cause the handle can be removing from outside.

4、选择的玻璃门拉手必须要和玻璃门匹配，这样拉手才会和牢固，与玻璃门搭配也才会更美观。

4、Finally is the most important，, the choice of glass door handle must be matched with the glass door, so that the handle will be firmly, and the glass door will be more beautiful with glass door handle.

拉手日常维护方法

1、请于装修完工并清洁现场后，才装拉手。防止施工过程中或清理现场时有磕伤碰花或清洁员工用含碱性清洁剂清洁拉手

2、每周至少清洁一次拉手表面

3、清洁拉手表面时请用柔软的干布抹擦，表面汗油或灰尘严重时，可用干布沾上滑石粉用力擦拭表面，即可光亮如新

4、千万不能用酸碱（含有腐蚀性）清洁剂清洁拉手，这样容易腐蚀金属表面引起氧化生锈